Features
PowerBus: 2 outputs, 16 + 2 channels, compatible with other servo bus systems
Servo-Match function: servo centre, end-points and reverse for all 24 servo outputs
Door sequencer: six freely programmable outputs with set-up assistant
SRS: Serial Receiver System provides the facility to use receivers with serial interface: Spektrum DSM2 and DSMX, Multiplex M-Link, Futaba S-Bus, HoTT, JR X-BUS and Jeti R-SAT2
Unrestricted channel assignment for all 24 PowerBox outputs
Graphic LCD screen with 128 x 64 pixels
Extremely user-friendly menu-based programming using the SensorSwitch
Up to 18 channels - depending on the radio control system in use
Signal amplification and interference suppression for all 24 outputs
Flight recorder, recording of lost frames, fail-safe events and all battery data
Variable frame rate, range 9ms – 21ms
Two 16-bit processors for fast, high-resolution signal processing
2 x double-regulated output voltages for receivers and servos
2 regulated voltage ranges with independent selection facility, 5.9V or 7.4V
Connection facilities for Futaba, Jeti, Spektrum, HoTT and Multiplex MSB downlink bus systems
Direct transmission of battery voltage, capacity, RX-data and GPS data to the transmitter
Separate voltage and capacity display for each battery
Minimum value memory alerts the user to voltage collapses
Large-area heat-sinks for high regulator performance
Regulator monitoring, regulator error indicator
Support for three battery types: LiPo, NiMH / NiCd, LiFePo
Suppression of any servo feedback currents which may occur
Updateable with PowerBox Systems USB Interface connectors
 
 
Technical Data
Operating voltage    4.0V - 9.0V
Power supply    2S LiPo, 2S LiIon, 2S LiFePo, 5S NiCd/NiMH
Current drain Power-on state    185mA (with LCD)
Current drain Standby    30µA
Maximum load current    Peak 4x20A
Drop-out voltage    0.3V
Output voltage    5.9V and/or 7.4V regulated
Signal input    serial
Supported RC systems    Spektrum, Futaba, HoTT, M-Link, Jeti, JR
Receiver redundancy    SRS
Channels    18
Servo sockets    24
Programmable servo outputs    24
Servo signal resolution    0.5µs
Signal frame rate    9ms, 12ms, 15ms, 18ms, 21ms
Screen    LCD, backlite
Integral door sequencer    yes
Supported telemetry systems    Futaba, Jeti, Spektrum, HoTT, M-Link
Dimensions    136 x 82 x 20 mm
Weight    158g
Weight Sensor Switch    15g
Weight of LCD screen    65g
Temperature range    -30°C to +75°C
 
 
Set contents
PowerBox Champion SRS
LCD screenSensorSwitch
2 three-core patch-leads, 180 mm
4 retaining screws
4 rubber grommets / brass spacer sleeves, fitted
Operating instructions in German and English